41
EXPLANATION OF TEST AND DATA DISPLAY
3
<DIP SW Settings Chart>
The DIP SW settings on the drive board can be used to set the steering wheel resistance, select whether to
perform the power on check, etc. Leave DIP SW 5-8 OFF.
The drive board is mounted on the sub electric unit (ASSY ELEC). Refer to “19-2” when changing the
settings.
DIP SW Settings: The grayed out settings are the defaults
1 2 3 Function
OFF OFF OFF Light
ON OFF OFF ↑
OFF ON OFF
ON ON OFF
OFF OFF ON
ON OFF ON ↓
ON ON ON Heavy
4 Function
OFF Perform power on check.
Do not perform power on check.
ON
4
<Drive Board Error Display>
If a problem occurs on the drive board, the test will not work when selecting DRIVE BD TEST on the
GAME TEST MODE screen. If this happens, an error number will be displayed on the 7-segment display
on the drive board. If a power on check error occurs, the 7-segment display will ash continuously.
First, check to make sure there is nothing wrong with the volume, motor, clutch, etc. in the steering wheel
mechanism.
5
When all setting adjustments are completed, select EXIT and press the TEST Button. The GAME TEST
MODE screen reappears.
Always recycle the power after making changes to the DIP SW settings. Operations are not performed for the new
settings.
The steering wheel recoil mechanism will wear out with age. If the recoil becomes weak, change the DIP SW
settings.
To Next Page
Loading...
