127
MAINTENANCE
loose. When replacing the brake gasket, the brake pad
must be replaced when the remaining limit thickness of
the brake pad is not less than 1mm.
5. Check the safety and surface condition of the disc. Use
the recommended brake cleaner or liqueur to clean any
grease. Do not use spray lubricants or other petroleum-
based products. If any damage (crack, excessive
corrosion, warping) is found, please check the dealer's
service before operation.
Brake oil
Use the recommended brake oil:
Brake Oil
DOT4
No adjustment is required for the hydraulic assisted braking
system. Check the brake oil level of the auxiliary braking
system frequently. If the level is shown to be low, perform
the following operations. The brake oil cup is located below
the front panel.
1. Remove the front shelf and the lower cover of the
instrument. See Page110 and 111 for the removal
method;
2. Observe the liquid level in the container:
To Next Page
Loading...
Need help?
General
