69
OPERATION
Clutch/belt
Proper run-in of the clutch and driving belt will ensure
longer service life and better performance. Run the run-in
clutch and belt at low speeds for the recommended run-
in time, only pulling light loads. Avoid violent acceleration
and high-speed running during run-in. If the belt is broken,
be sure to clean up the Intake and outlet pipeline and any
debris from the clutch and engine compartment during belt
replacement
New operator driving procedures
1. Wear protective riding gear. See the Safe Riding Gear
section.
2. Perform the pre-ride inspection.
3. Place the transmission in PARK.
4. Mount the vehicle from the left side.
5. Sit upright with both feet on the footrests and both
hands on the handlebars.
6. Start the engine and allow it to warm up.
7. Drive slowly. Practice maneuvering and using the
throttle and brakes on level surfaces.
To Next Page
Loading...
Need help?
General
