92
OPERATION
more than one minute or close to the rated load. If the
winch motor feels very hot, stop winch and let it cool
for a few minutes.
◆
The rope end cannot bear the full load, and the rope
must rotate around the drum at least 5 laps.
◆
Avoid pulling the from extreme angles, as this will
cause the rope to be rolled on One end of the barrel
and damage the rope.
◆
Note that the rope-drawing capacity of the winch is the
maximum rope-drawing capacity of the first layer, only
the first the layer can only be pulled, do not operate the
winch with overload capacity.
◆
Never hook the rope back to itself, otherwise the rope
will be damaged. Use trunk protection protector.
◆
Before operation, make sure that the winch is firmly
installed on the vehicle or bracket.
◆
Before moving heavy objects, check the wire rope to
prevent kinks and uneven wire layers. The slack rope
must be properly tightened under a weight of about
100Kg.
◆
When pulling the load, be sure to lay a blanket or
protective layer on the wire rope near the hook end.
This will prevent the possibility of breaking the wire
rope and help prevent serious injuries and damage.
To Next Page
Loading...
Need help?
General
