SEH PS Series - Page 37

Network Settings
Print Server User Manual Windows 32
Configuring IPv4 Parameters via the Print Server Homepage
Proceed as follows:
1. Start the Print Server Homepage.
2. Select Configuration – TCP/IP.
3. Configure the TCP/IP parameters; see: Table 2
32 .
4. Click Save to confirm.
 The settings are saved.
Table 2: TCP/IP Parameters
Parameters Description
IP address IP address of the print server
Subnet Mask Subnet mask of the print server
Gateway Gateway address of the print server
Multicast router as gateway If this parameter has been enabled, it will be
attempted to automatically enter the address of the
found multicast router as gateway address.
If disabled, the gateway address has to be entered
manually.
Host name Host Name of the print server
Contact person Freely definable description
Location Freely definable description
DHCP
BOOTP
ZeroConf
Enables/disables the protocols 'DHCP', 'BOOTP',
and 'ZeroConf'.
Protocols offer various possibilities to save the IP
address in the print server.
We recommend disabling these options once an IP
address has been assigned to the print server.