Network Settings
Print Server User Manual Windows 36
Table 3: IPv6 Parameters
Configuring Logical Printers via the InterCon-NetTool
Requirements
The InterCon-NetTool is installed on the client, see: 15.
1. Start the InterCon-NetTool.
2. Double-click the print server in the device list.
The Settings dialog appears.
3. Click Configuration – IPv6.
4. Configure the IPv6 parameters; see: Table 3
36
.
5. Click OK to confirm.
The settings are saved.
Parameters Description
IPv6 Enables/disables the IPv6 functionality of the print server.
IPv6 address Defines a print server IPv6 unicast address assigned
manually in the format n:n:n:n:n:n:n:n.
Every 'n' represents the hexadecimal value of one of the
eight 16 bit elements of the address. An IPv6 address may
be entered or displayed using a shortened version when
successive fields contain all zeros (0). In this case, two
colons (::) are used.
Router Defines the IPv6 unicast address of the router. The print
server sends its 'Router Solicitations' (RS) to this router.
Prefix length Defines the length of the subnet prefix for the IPv6 address.
The value 64 is preset.
Address ranges are indicated by prefixes. The prefix length
(number of bits used) is added to the IPv6 address and
specified as a decimal number. The decimal number is
separated by '/'.
Automatic configuration Enables/disables the automatic assignment of the IPv6
address for the print server.
To Next Page
Loading...
