Section 9: General Repairs
Repair Instructions
2016 Bambi MAX Service Manual – Models 1518-3542 (Version E) 61
We Engineer Solutions
If the IDS is too tight, adjust two of the spokes as follows:
1. Cut off the spoke just above the existing hole on one end only.
Then, redrill a new hole centred the same distance from the new
end of the spoke as the other spokes. This will likely produce a
good fit.
2. If the IDS is still too tight remove another spoke and repeat the
above steps.
3. These two spokes are across from each other.
To Next Page
Loading...
