Sekonic ST-50M - Chapter 3. Preparation for Measurement (Continued); Inserting the SD Card (ST-50 M); Removing the SD Card (ST-50 M)

- 14 -

Inserting the SD card (ST-50M only)
①
Set the [SD Card Record] switch to OFF.
②
Insert the SD card until it clicks into place in the SD card
slot.
③ 【
MEMORY
】
blinks for a short time on the LCD. This indi-
cates that the information in the SD card is being loaded.
④
When blinking of [MEMORY] on the LCD is finished, data
can be written to the SD card.
⑤
To start writing to the SD card, set the [SD Card Record]
switch to ON.

Removing the SD card (ST-50M only)
①
Set the [SD Card Record] switch to OFF.
②
Check that
【
MEMORY
】
no longer appears on the LCD.
③
Gently press in the SD card inserted into the SD slot with
your finger until the SD card makes a clicking sound. The
SD can now be removed.
Sensor terminal
Alarm output terminal
AC adapter terminal
[Side view]