Sekonic ST-50M - Chapter 7. Setting Alarm (Continued); Setting Temperature Alarms; Setting Humidity Alarms

- 22 -
【ALARM】
『MODE』
【ENTER】
【ALARM】
7-2. Setting temperature alarm
①
Press the
【
ALARM
】
key once while the normal mea-
surement screen is displayed.
『
MODE
』
and
『
ALARM
』
will appear. When the alarm is already set, H and / or L
will also be displayed.
②
Press the
【
ALARM
】
key once again.
『
A1
』
and
『
H
』
will
be on the display, with the present set point (or -- °C/°F
in initial state) blinking.
③
Set the desired upper limit of the temperature with the
【▲】
or
【▼】
key, then press the
【
ENTER
】
key. The
set point will stop blinking to show the setting has been
completed. The indication
『
- -
』
means that no value has
been set.
④
Press the
【
ALARM
】
key once again.
『
A2
』
and
『
L
』
will
be on the display, with the present set point (or -- °C/°F
in initial state) blinking.
⑤
Set the desired lower limit of the temperature with the
【▲】
or
【▼】
key, then press the
【
ENTER
】
key. The
set point will stop blinking
to show the setting has been
completed. The indication
『
- -
』
means that no value has
been set.
Reference
To exit this mode after setting the temperature alarm,
press the
【
ALARM
】
key four times. The normal mean-
surement screen will be restored.
7-3. Setting humidity alarm
①
After setting the lower limit of the temperature, press the
【
ALARM
】
key once.
『
A3
』
and
『
H
』
will be on the display,
with the present set point (or -- % in initial state) blinking.
②
Set the desired upper limit of the humidity with the
【▲】
or
【▼】
key, then press the
【
ENTER
】
key. The set point
will stop blinking to show the setting has been complet-
ed. The indication
『
- -
』
means that no value has been
set.
③
Press the
【
ALARM
】
key once again.
『
A4
』
and
『
L
』
will
be on the display, with the present set point (or -- % in
initial state) blinking.
④
Set the desired lower limit of the humidity with the
【▲】
or
【▼】
key, then press the
【
ENTER
】
key. The set point
will stop blinking to show the setting has been complet-
ed. The indication
『
- -
』
means that no value has been
set.
7-4. To initialize the alarm
The alarm setting can be initialized (cleared). Skip this
paragraph, if not required.
①
After setting the lower limit of the humidity, press the
【
ALARM
】
key once. The
【
CLEAR
】
indicator will appear
and start blinking.
②
Press the
【▼】
and
【
ENTER
】
keys together to initialize
(clear) the alarm setting. Note that the
『
A5
』
indicator
will change to
『
A0
』
. To return to the normal measure-
ment screen, press the
【
ALARM
】
key six times.