-
10
-
Setting (Replacing) chart paper
①
While pressing the stoppers on both sides of the chart
cassette, pull forward and remove it from the body.
CAUTION
• When replacing the chart paper, make sure that the
recording pens are raised. If not, this procedure may
cause damage to the instrument.
• See “Setting (Replacing) recording pens” in this
manual if the pens need to be raised.
Chapter 3. Preparation for Measurement
③
Release the chart holders of the chart cassette, raising
the rear one (silver metal) and pulling down the front one
(transparent plastic), then insert the chart paper as the
arrow shows in the figure.
CAUTION
• Set the chart paper so that it is fed to the front. Set-
ting it in the opposite direction may cause the ma-
chine trouble.
• Set the chart paper so that the square holes come to
the left side and the rectangular holes come to the
right side.
CAUTION
Be sure to set the chart paper in the correct direc
tion.
②
Fan the chart paper carefully before setting.
④
Pull out the end of the chart paper approx. 20 cm/7.87 in.
(3 or 4 teeth) and set it to the drum so that the teeth of
the sprocket wheel are properly engaged in the holes on
both sides of the chart paper.
Stopper
チャート紙
Chart paper
Drum
Chart holders
Chart paper
チャート紙
Chart paper
To Next Page
Loading...
