Sekonic ST-50M - Chapter 5. SD Card Writing Function (ST-50 M Only) (Continued); Changing the Date Setting; Changing the Time Setting

- 18 -
Reference
・
The display returns to the measurement screen if no
operation is performed within one minute.
Reference
・When the time setting is registered, the seconds are reset
to 0.
・The display returns to the measurement screen if no op -
eration is performed within one minute.
5-4. Changing the Date
①
Pressing the
【
FUNCTION
】
key three times in the normal
measurement screen shows
【
MODE
】
,
【
DATE
】
, and the
year, month, and day. The year is blinking.
②
Use the
【▲】
and
【▼】
keys to change the year, and then
press the
【
ENTER
】
key to change the blinking from the
year to the month.
③
Use the
【▲】
and
【▼】
keys to change the month, and
then press the
【
ENTER
】
key to change the blinking from
the month to the day.
④
Use the
【▲】
and
【▼】
keys to change the day, and then
press the
【
ENTER
】
key to change the indicator from
blinking to fully lit and register the setting.
⑤
To return to the normal measurement screen, press the
【
FUNCTION
】
key.
5-5. Changing the Time
①
Pressing the
【
FUNCTION
】
key four times in the normal
measurement screen shows
【
MODE
】
,
【
TIME
】
, and the
hours and minutes. The hours are blinking.
②
Use the
【▲】
and
【▼】
keys to change the hour, and
then press the
【
ENTER
】
key to change the blinking from
the hour to the minute.
③
Use the
【▲】
and
【▼】
keys to change the minute, and
then press the
【
ENTER
】
key to change the indicator
from blinking to fully lit and register the setting.
④
To return to the normal measurement screen, press the
【
FUNCTION
】
key.
CAUTION
・The clock of this instrument is set to Japan Standard
Time.
Before using for the first time, the time must be set for
your region.
・Automatic correction for summer time (daylight savings
time) is not supported.