Selco M4200 - Unblock Delays; Reset Functions; Factory Default

M4200 - User manual
Revision: 07.03.2017 Page 32
Parameter
Command
Description
Unblock
delays
WRITE SYS BLOCK1 UBDELAY 1S
Block function 1 has a delay on 1sec. from unblock to
respond (unblocked)
1s – 999s
WRITE SYS BLOCK2 UBDELAY 1S
Block function 2 has a delay on 1sec. from unblock to
respond (unblocked)
are accepted
values
Reset
functions
WRITE SYS RESET PUSH 1
1 push on reset button: Resets all
WRITE SYS RESET PUSH 2
2 push on reset button: First reset siren Second reset
LEDs
Factory
default
WRITE SYS SETUPDEFAULT NO
This command is used to undo the command: WRITE
SYS SETUPDEFAULT YES (before the power supply
has been disconnected)
WRITE SYS SETUPDEFAULT YES
Cancels all settings. The complete configuration will
return to factory default (the factory default setting will take
effect, when power supply has been disconnected)
NOTE
The first set of commands in each parameter group in the table above is always the factory default settings
of the alarm monitor.