Select Engineered Systems Select Gate 1A - Factory Defaults and Programming Functions

SELECT GATE SG-1A V1.X
SELECT ENGINEERED SYSTEMS 11/01 19
4.2 FACTORY DEFAULTS AND PROGRAMMING FUNCTIONS
Listed below are all the default factory parameters of Select Gate. The number to the right
of the default description refers to the section in this manual where changing the default is
described. All these default changes assume that programming mode has already been entered
from either the keypad or a phone, either in the house or residence or from an outside line.
DESCRIPTION RANGE PARAMETERS DEFAULT
11 Phone Code 0 - 9
12 Pin Code 00 - 99 WW XXXX Y Z
21 Relay 1 Unlock Tone 0 - 9 6
22 Relay 1 Latch Tone 0 - 9 0
23 Relay 1 1 Hour Unlock Tone 0 - 9 0
24 Relay1 Open Time 00 - 99 seconds 2
26 Strike out Count 0 - 9 0
27 Lock Out Time 0 - 4 minutes 0
31 Relay 2 Unlock Tone 0 - 9 0
32 Relay 2 Latch Tone 0 - 9 0
33 Relay 2 1 Hour Unlock Tone 0 - 9 0
34 Relay 2 Open Time 00 - 99 0
41 Ring Type 1 - 4 SS SL LS LL 1 (SS)
42 Ring Count 1 - 9
44 Call Waiting Type 1 - 4 SS SL LS LL 1(SS)
45 Ring Detect 00 - 99 09
46 Back Beep 0 - 1 0
47 Talk Time 1 - 9 minutes 1
48 Keypad On 0 - 1 0
51 Programming Password 4 digits 7777
61 Call Forward Tone 0 - 9 0
62 Call Forward Type
64 Call Forward Number Up to 16 digits
65 Call Forward ON/OFF 0 - 1 0
91 Clear All Phones