Select Engineered Systems Select Gate 1A - System Settings and Operation

SELECT GATE SG-1A V1.X
SELECT ENGINEERED SYSTEMS 11/01 23
23
5
23
3
NOTE: IF THE SAME TOUCH-TONE™ NUMBER IS USED FOR RELAY 1
AND RELAY 2, BOTH RELAYS WILL LATCH AT THE SAME TIME.
4.2.11 RELAY 2 ONE HOUR TONE (Function 33)
Relay 2 is energized for one hour when the house calls Select Gate, enters the 2 digit
control password and presses a valid unlock Touch-Tone™.
To change from the default of 0 (disabled) to 8:
4.2.12 RELAY 2 OPEN TIME (Function 34)
This is the length of time that relay 2 is energized when the house presses a valid unlock
tone. This time can be programmed from 1 to 99 seconds.
To change from the default of 10 to 5:
Note the leading "0" for time less than 10 seconds.
4.2.13 RING TYPE (Function 41)
There are 4 types of ring combinations for ringing the house or residence phone. This
makes it easy to determine if a call is from an outside line or from the Select Gate location. The
four combinations are shown in the table below:
RING TYPE
1 SHORT SHORT
2 SHORT LONG
3 LONG SHORT
4 LONG LONG
To change from the default of Ring Type 1 (short short) to Ring Type 3 (long short):