Select Engineered Systems Select Gate 1A - Page 29

SELECT GATE SG-1A V1.X
SELECT ENGINEERED SYSTEMS 11/01 25
4
6
1
5
4
7
1
4
8
1 3
2
4
1
5
If less than 10 rings are required don't forget to put a "0" in front of the ring (05 not 5).
4.2.17 BACK BEEP (Function 46)
Back beep is a function that puts a tone onto the phone line every ten seconds, whenever
the Select Gate has called an out side phone line. This allows someone called on an outside
phone line to know that the caller is calling from the Select Gate.
To change Back beep from the factory default of disabled (0) to enabled (1):
4.2.18 TALK TIME (Function 47)
Talk time is the time the Select Gate stays energized when calling a number on the outside
line. (Not the house.) The range is from 1 to 9 minutes
To change from the default of 1 minute to 5 minutes:
4.2.19 KEYPAD ON (Function 48)
This function, when enabled keeps the Select Gate keypad active for keying in the Touch
Tone numbers 0 - 9. * and # are not allowed.
To change from the default of 0 (off) to 1 (on): :
4.2.20 PROGRAMMING PASSWORD (Function 51)
This is the 4 digit number that allows all parameters, function definitions, PIN codes, phone
numbers, timers, and all programmable features to be changed.
To change from the default password number 7777 to 4321: