Sena CAVALRY LITE - Wearing the Helmet

MENU
1. About the
CAVALRY LIte
bLuetooth hALf
heLmet
Sena Cavalry Lite Bluetooth
®
Half Helmet | 10
General
Information
Product
Details
Wearing
the Helmet
Pre-Ride
Helmet
Inspection
Accessory
Installation:
Ear Plates
Accessory
Installation:
Ear Pads
1.3 Wearing the Helmet
1.3.1 Putting on the Helmet
1. Unfasten the chinstrap.
2. Gently pull the padded V-straps outward
and slide the helmet onto your head.
Note: A “chinstrap” is the nylon webbing
that goes through the D-Rings.
3. Route the chinstrap under your chin, then
thread it through both D-Rings.
4. To fasten securely, thread chinstrap back
through the D-Ring closest to your neck,
and pull.
Thread through
the D-Rings
Chinstrap
Note: Check the chinstrap’s position and
tension regularly to ensure proper fit.
1.3.2 Removing the Helmet
1. Loosen the chinstrap by pulling the red tab
attached to the D-Rings.
2. Pull the chinstrap out from within the
D-Rings.
3. Gently pull the padded V-straps outward
and slide the helmet off your head.
Advice: Fastening the chinstrap after
removing the helmet will help avoid
scratching surfaces it’s placed upon.