Maintenance, Repair and Troubleshooting
Table 4: Take-off vetos
eMotion text Description and User action
Drone not
horizontal (roll or
pitch)
The eBee must be held horizontally with level wings
to initiate take-off.
User action: Hold the drone horizontally.
Motor is blocked Excessive current was detected from the motor.
User action: Check that the propeller is mounted
correctly and that the motor is freely turning and try
the take-off procedure again.
Battery too low for
take-off
The drone requires a fully-charged battery for the
take-off procedure.
User action: Change the battery.
Wings not
detected
The drone’s wings are not attached correctly or the
wing struts are damaged.
User action: Ensure that the wings are fully inserted
into the main body and that the wing struts are not
damaged, as described in section ‘Preparing the eBee
for flight’ on page 28.
USB cable
detected
The eBee has detected a USB cable connected to the
drone’s autopilot.
User action: Remove the USB cable before take-off.
142
To Next Page
Loading...
