senseFly eBee - Pre-Flight Errors

Maintenance, Repair and Troubleshooting
8.1 Pre-flight errors
As soon as the battery is connected to the drone it performs a series of pre-flight
checks to thoroughly test its on-board systems. The start-up process is described
in detail in section ‘Preparing the eBee for flight’ on page 28. If an error occurs
during these pre-flight checks the status LED will blink red and a description of
the error will appear in eMotion. In most cases, re-connecting the battery will
suffice to removethe error. Table 3 presents all the Pre-flight errorsthat may occur
and possible actions to fix the error. If the problem is related to the firmware in
the on-board autopilot, try re-loading the firmware using instructions in section
‘Updating the eBee software’ on page 128. If an error persists after reconnecting
the battery several times we recommend you report the problem by following the
instructions in section ‘Reporting a problem with your eBee’ on page 160.
Table 3: Pre-flight errors
eMotion text Description and User action
Incorrect firmware
detected
There is an error with the current version of the
firmware in the eBee’s autopilot.
User action: Re-load the correct firmware⁵⁴.
Battery too low for
take-off
The battery level is too low to perform a take-off.
User action: Re-connect a fully-charged battery.
Drone flight log
memory full
The memory card used to store the Drone flight log is
full.
User action: Empty the memory card by follow-
ing the instructions in section ‘Importing images and
flight data’ on page 48.
⁵⁴ see section ‘Updating the eBee software’ on page 128
138