Quick start guide
2.2 Preparing the eBee for flight
The eBee’s simple design means it can go from the box to being ready for flight
in minutes. We recommend that you perform the following 6 steps before every
flight to ensure that the platform is best prepared for flight.
Note: Remove the red warning sticker from the motor before your
first flight.
Step 1: Perform a general inspection
Visually inspect the drone for damage or wear using the following steps:
1. Check the foam central body and wings for cracks or other damage.
2. Verify that the pitot probe is properly attached to the airframe and that the
holes in the probe are free of obstructions.
3. Verify that the ground sensor is free of obstructions and that the sensor’s
lens is clean.
28
To Next Page
Loading...
