Troubleshooting
8.2 Take-off vetoes
After successfully completing pre-flight checks the status LED becomes a solid
green to indicate that the drone is ready for take-off. At this point the eBee con-
tinues to monitor its sensors and battery level. If at any point the drone detects
a condition that prevents it from beginning the automatic take-off procedure it
displays a Take-off veto in eMotion and the status LED changes to a blue pulse.
Once the Take-off veto is cleared the status LED returns to a solid green colour to
indicate that the drone is ready for take-off.
Table 4 on the following page presents all the Take-off vetoes that may occur and
possible actions to remove the veto. If a veto persists after performing the sug-
gested action, we recommend you report the problem by following the instruc-
tions in section ‘Reporting a problem with your eBee’ on page 160.
141
To Next Page
Loading...
