Maintenance, Repair and Troubleshooting
Back wind,
landing precision
decreased
∗∗∗
(in blue)
There are no approach sectors available against the
direction of the wind. The eBee has calculated a Lin-
ear landing approach direction in the direction of the
wind.
Security action: The eBee continues normal flight.
User action: Add a new approach sector against the
direction of the wind, if possible, abort the landing
and try landing again. If not, be ready for the eBee
to overshoot its planning Linear landing location by
preparing a larger obstacle-free zone around the lo-
cation.
Strong wind
∗
The wind is too strong for the eBee to navigate safely.
Security action (if enabled): The eBee flies towards
the Home waypoint at an altitude defined by the
Home waypoint’s Change altitude parameter (by de-
fault, set to ‘Highest’).
User action: Land as soon as possible and wait for
better flight conditions.
Cannot maintain
altitude
The eBee cannot maintain the altitude that is com-
manded by the flight controller. This may be due to a
damaged motor, airframe or ailerons or a strong ver-
tical wind.
Security action: The drone continues normal flight.
User action: If the condition persists during a flight,
land and wait for the wind to decrease, as explained
in section ‘Weather check’ on page 27. If the prob-
lem occurs in low-wing conditions perform Check 2
in section ‘Full airframe and sensor inspection’ on
page 131.
154
To Next Page
Loading...
