Executing a flight
preflight checks failed
blue
pulse
status LED:
green
solid
status LED:
ready for startup
connect battery
red
blink
status LED:
disconnect battery
connect battery and
insert into
compartment
close battery
compartment
Startup
process:
Step 5: Install and connect the battery
Lay the eBee horizontally on the ground outside in the vicinity of the take-off lo-
cation, with the top face up. To install the battery, begin by connecting the power
cables to the battery. Insert the connectors firmly to the end in order to avoid un-
desired disconnection when in flight. Once connected, insert the battery into its
compartment and close the compartment lid.
Caution: Take care to keep the propeller area clear, in case it sud-
denly starts spinning.
33
To Next Page
Loading...
