Advanced functionalities
Table 1: Simulator bar buttons
Button Description
Pause Clicking the pause button will pause the simulation
and thus stop the drone while in flight. This can be
useful when you wish to change parameters or way-
points while the drone is already in flight. Note: this
is a simulated action that is not possible with the
real eBee. Instead of pausing while in flight we
recommend that you use the ‘HOLD POSITION’
function to better simulate real flight conditions.
Play Clicking the play button returns the simulation to ac-
tual speed from the pause or fast-forward conditions.
Fast forward Clicking this button increases the speed of the simu-
lation to 4x actual speed. This allows you to shorten
the time required to simulate a complete mission.
Re-position
take-off location
Clicking this button and then clicking on a location
in the Map Area simulates the action of connect-
ing the battery to the drone in a new location. The
drone is returned to the ground at the new location
and runs through its pre-flight checks before enter-
ing Idle mode.
Initiate take-off Clicking this button simulates a take-off procedure,
including the motor power-up sequence and the
hand launch³⁰.
³⁰ see section ‘Take-off’ on page 41 for a description of the take-off procedure
88
To Next Page
Loading...
