Installation CDHD
16 Servotronix
Crimping tools, if you are not using ready-made cable assemblies:
Connector P1 (STO): Molex crimper 0638190000
Connectors P2 (Motor Power), P3 (Regen) and P4 (AC Input):
JST crimper YRF-1070. If a crimp pin extraction tool is needed, use
JST extraction tool EJ-JFA J3.
M4 ring or spade terminal.
A small slotted screwdriver for setting the drive address switches.
For connection to the host computer, use one of the following:
USB 2.0 A to Mini-B cable (USB interface)
4p4c plug and cable (RS232 interface)
3.2.2 Computer Requirements
To install and run ServoStudio software, the GUI-based configuration and testing
environment, the following computer system is required:
2 GHz CPU
1 MB RAM
1000 MB available on hard drive (after .net 4 is installed)
USB port for connecting to the drive
Operating system: Windows XP-SP3, or Windows 7
.Net4 installed (for details, refer to .NET Framework System Requirements).
If .NET 4 is not installed on the computer, ServoStudio will guide you
through the installation, but will not install it automatically.
To Next Page
Loading...
