Sharp AJ-6020 - Driver Installation for Windows 95

29
INSTALLING THE "AJ-6000 SERIES DRIVER"
Installing onto Windows 95
1
Make sure that the unit is connected to your computer.
2
Turn on the unit, and then turn on your computer.
"Update Device Driver Wizard" or "New Hardware Found" window will appear.
If the "Update Device Driver Wizard" window appears, click the
"Next" button and proceed to step 3.
If the "New Hardware Found" window appears, perform the
following steps and proceed to step 6.
1.
Check the radio button for "Driver from disk provided by hardware manufacturer",
and click the "OK" button.
2.
Insert the supplied CD-ROM into your CD-ROM drive.
3.
Type "D:\DRIVERS\MFP-PS\ENGLISH\WIN95", and then click the "OK" button.
(Change "D" to correspond to the letter of your CD-ROM drive.)
The setup program will start to copy the files.
Go to step 6.
3
Click the "Other Locations" button.
4
Insert the supplied CD-ROM into your CD-ROM drive.
If neither of "Update Device Driver Wizard" nor "New Hardware Found" wizard
appear, refer to "Installing through Setup". (See page 36)