76
SPECIAL FUNCTIONS
Adding a original to polling memory:
Use this procedure to add an original to another
original that has already been scanned into polling
memory. Place the original in the RSPF or on the
document glass and follow the steps below.
1
Press the [MENU] key.
2
Press the [ ] key ( ) or [ ] key ( )
until "7:MEMORY POLL MODE"
appears, and then press the [ENTER]
key.
3
Press the [ ] key ( ) or [ ] key ( )
until "1:SET" appears, and then press
the [ENTER] key.
4
Press the [ ] key ( ) or [ ] key ( )
to select the number of times polling
transmission will take place and press
the [ENTER] key.
"1:1 TIME" or
"2:REPEAT" can be
selected as the number
of polling operations
allowed.
5
Press the [START] key ( ).
Deleting originals from polling memory:
Follow the steps below to delete originals that have
been scanned into polling memory.
1
Press the [MENU] key.
2
Press the [ ] key ( ) or [ ] key ( )
until "7:MEMORY POLL MODE"
appears, and then press the [ENTER]
key.
3
Press the [ ] key ( ) or [ ] key ( )
until "2:CLEAR" appears, and then
press the [ENTER] key.
4
Press the [START] key ..
"7:MEMORY POLL MODE"
Selection
"1:SET"
Selection
"7:MEMORY POLL MODE"
Selection
"2:CLEAR"
Selection
!AR-FX13_sec.book 76 ページ ２００７年１１月２８日 水曜日 午後４時２２分
To Next Page
Loading...
