74
TONER CARTRIDGE REPLACEMENT
When toner is low, the error indicator will light up and "TONER CARTRIDGE IS
NEAR EMPTY." will appear in the display to alert you to purchase a new toner
cartridge. If copying is continued while the indicator is lit, copies will gradually
become lighter until the toner runs out. When the toner runs out, the machine will
stop operating, the error indicator will blink, and "REPLACE THE TONER
CARTRIDGE" will appear in the display. Follow the procedure below to replace the
toner cartridge.
1
Open the bypass tray, and
then open the side cover
while pressing the side
cover open button.
2
Push gently on both sides of
the front cover to open the
cover.
• After the machine stops, it may be possible to make a few more
copies by taking the
toner cartridge out of the machine, shaking it
horizontally, then reinstalling it. If copying is not possible after this
operation, replace the
toner cartridge.
• During a long copy run of a dark original, "TONER
REPLENISHMENT IN PROGRESS" appears in the display, and the
machine may stop even though toner is left. The machine will feed
toner up to 2 minutes and then the ready indicator will light up. Press
the [START] key ( ) to resume copying.
Note
!AR-208S_208D.book 74 ページ ２００７年１２月３日 月曜日 午後３時３３分
To Next Page
Loading...
Need help?
General
