Sharp AR-208D User Manual

- 9 -
USER PROGRAMS FOR THE
NETWORK EXPANSION KIT
When the network expansion kit is installed in the machine, the following programs are added to the
user programs for Print mode.
The IP address and other network settings are configured using these user programs.
Additional user programs for Print mode
The procedure for selecting a user program setting is explained in "SELECTING A SETTING FOR
A USER PROGRAM" in the operation manual.
Program
number
Program name
Settings (factory
default settings
appear in bold)
Explanation
4 ENABLE TCP/IP
1: YES
2: NO
This program must be enabled to use the
machine on a TCP/IP network. "IP ADDRESS
SETTING" must also be configured.
This program is initially enabled (factory default
setting).
5 ENABLE DHCP
1: YES
2: NO
If "YES" is selected (factory default setting) and
the machine is connected to a TCP/IP network,
the IP address will be acquired automatically.
If you will manually assign an IP address using
"IP ADDRESS SETTING", select "NO".
6
IP ADDRESS
SETTING
• IP ADDRESS
• SUBNETMASK
• DEFAULT GATEWAY
This program is used to set the IP address (IP
address, Subnet Mask, and Gateway) of the
machine when TCP/IP protocol is used on the
network.
When "ENABLE DHCP" is selected, the
machine will obtain an IP address
automatically. This is the factory default setting.
7
ENABLE
NETWARE
1: YES
2: NO
This program must be enabled to use the
machine on a network that uses NetWare
protocol.
This program is initially enabled (factory default
setting).
8
ENABLE
ETHERTALK
1: YES
2: NO
This program must be enabled to use the
machine on a network that uses EtherTalk
protocol.
This program is initially enabled (factory default
setting).
9
ENABLE
NETBEUI
1: YES
2: NO
This program must be enabled to use the
machine on a network that uses NetBEUI
protocol.
This program is initially enabled (factory default
setting).
Note

Sharp AR-208D Specifications

General

Brand	Sharp
Model	AR-208D
Category	All in One Printer
Language	English