LOADING PAPER
18
Loading paper in the bypass tray
1
Open the bypass tray and extend the tray.
2
Set the bypass tray paper guides to the paper width. Insert the
paper (print face down) all the way into the bypass tray.
3
Press the [TRAY SELECT] key ( ) to select the bypass tray.
• Paper must be fed narrow side first into the feed slot.
• Special papers such as transparency film, labels, and envelopes
must be fed one sheet at a time through the bypass tray.
• When copying onto transparency film, remove each copy promptly.
Do not let copies stack up.
To close the bypass tray, perform step and then step in the
illustration and push the round projections at the right of the tray
until they click.
Note for loading thick paper
Copying on thick paper requires higher fusing temperature setting. Set the user
program 29 to "2 (HEAVY PAPER)" when using thick paper. (See page 57.)
Note
Note
1
1
1
2
1
2
Print face
!002-Paper.fm 18 ページ ２００７年１２月２０日 木曜日 午前１０時２分
To Next Page
Loading...
Need help?
General
