USER SETTINGS
56
11
2-SIDED COPY
MODE*
1: HI-SPEED
2: NORMAL
• If the memory fills up when two-
sided copying is performed,
"NORMAL" can be selected to
make copying possible.
However, "NORMAL" results in a
slower copying speed. Normally
"HI-SPEED" is selected to
enable fast two-sided copying.
12 MARGIN WIDTH
1: 1/4"
2: 1/2"
3: 3/4"
4: 1"
• Use this setting to set the
margin width.
13
MEM. FOR
PRINTER
1: 30%
2: 40%
3: 50%
4: 60%
5: 70%
• Use this to change the
proportion of machine
memory used for printer
mode.
14
AUTO KEY
REPEAT
1: ON
2: OFF
• Use this setting to select
whether or not holding down a
key causes repeated input of
the key. For keys that normally
cause a set value to decrease
or increase when held down
(for example, the [ ] key
( ) or [ ] key ( )), this
program can be used to have
the set value not change
when the key is held down.
15 KEY PRESS TIME
1: NORMAL
2: 0.5 SEC.
3: 1.0 SEC.
4: 1.5 SEC.
5: 2.0 SEC.
• Use this setting to select how
long a key must be pressed
for the input to be accepted.
By selecting a longer time,
you can prevent settings from
being changed by the
accidental pressing of a key.
16
KEY TOUCH
SOUND
1: LOW
2: HIGH
3: OFF
• This sets the volume of beep
signals. (p.60)
17
SOUND AT
DEFAULT
1: ON
2: OFF
• Use this to sound a beep
when a base setting is
selected. (p.60)
18
TONER SAVE
MODE
1: ON
2: OFF
• This mode reduces toner
usage by about 10% when
copying. Toner save mode is
effective when the exposure
mode is AUTO or TEXT.
Program
number
Program name
Setting codes
(factory default
setting appears
in bold)
Explanation
* AR-208D only
!AR-208S_208D.book 56 ページ ２００７年１２月３日 月曜日 午後３時３３分
To Next Page
Loading...
