Sharp DX-C200P - Receiving an IP Address for Ipv6 Automatically (DHCP)

Receiving an IP Address for IPv6 Automatically (DHCP)
• When you use this printer in the DHCP environment with IPv6 protocol, select [DHCP] following this
procedure.
• Consult your network administrator for information about making network settings.
1. Press the [Menu] key.
CER408
2. Press the [ ] or [ ] key to display [Host Interface], and then press the [OK] key.
Menu:
Host Interface
3. Press the [ ] or [ ] key to display [Network Setting], and then press the [OK] key.
Host Interface:
Network Setting
4. Press the [ ] or [ ] key to display [IPv6 Config.], and then press the [OK] key.
Network Setting:
IPv6 Config.
5. Press the [ ] or [ ] key to display [IPv6], and then press the [OK] key.
IPv6 Config.:
IPv6
6. Press the [ ] or [ ] key to display [On], and then press the [OK] key.
IPv6
On
4. Configuration
48