Paper Recommendations
Loading Paper
• Do not use ink-jet printer paper because it may stick to the fusing unit and cause a paper misfeed.
• Do not load OHP transparencies. Load translucent media only.
• Set the paper as described below
• Tray 1: Print side facing up
• Paper Feed Unit (Tray 2): Print side facing up
• Bypass Tray: Print side facing down
• Print quality cannot be guaranteed if paper other than the ones recommended is used. For more
information about recommended paper, contact your sales or service representative.
• Do not use paper that has already been printed onto by other printers.
• When loading the paper, take care not to touch the surface of the paper.
• Do not use dirty or damaged paper.
• Specify the paper size and type using control panel.
• The remaining paper indicator on the right front side of the paper tray shows approximately how
much paper is remaining.
Storing Paper
• Paper should always be stored properly. Improperly stored paper might result in poor print quality,
paper misfeeds, or printer damage. Recommendations are as follows:
• Avoid storing paper in humid areas.
• Avoid exposing paper to direct sunlight.
• Store on a flat surface.
• Keep paper in the package in which the paper came.
Types of Paper and Other Media
This section provides information about the type of paper supported by this printer and cautions for use.
Paper Recommendations
55
To Next Page
Loading...
Need help?
General
