7. Press the [ ] or [ ] key to display [DHCP], and then press the [OK] key.
IPv6 Config.:
DHCP
8. Press the [ ] or [ ] key to select [On], and then press the [OK] key.
DHCP:
On
The address will be detected by the printer
9. Press the [Menu] key.
10. If you are requested to restart the printer, turn off the printer, and then turn it back on.
11. Print a configuration page to confirm the settings made.
• For details about printing the configuration page using control panel, see p.30 "Test Printing".
Setting the Ethernet Speed
You can set the speed that the printer will use for Ethernet communication. For normal usage, the default
setting [Auto Select] is suitable and does not need to be changed. This setting allows two connected
interfaces to automatically determine the optimum speed that they will communicate at.
Router/HUB Printer
[10Mbps
Half D.]
[10Mbps Full
D.]
[100Mbps
Half D.]
[100Mbps
Full D.]
[Auto Select]
10Mbps Half
Duplex
10Mbps Full
Duplex
100Mbps Half
Duplex
100Mbps Full
Duplex
auto-
negotiation
(auto selection)
Ethernet Configuration
49
To Next Page
Loading...
Need help?
General
