Initial Set-up
10
Document Solutions After Sales Service
DEVELOPER INSTALLATION
Sim 25-02 Auto Developer Adjustment
Select CMYK
Note: Toner Installation should be performed after
Auto Developer Adjustment is completed
For Optimum Image Quality it is recommended to
install developer at the customer site
INITIAL SETTINGS
Sim 26-06 Machine Destination Set
Sim 26-52 Blank Paper Count Mode Setting (Non Print)
Sim 26-65 Finisher Alarm mode
Select Staple sheet limit (30 or 50)
Staple copies/sets limit (ON/OFF)
Sim 26-01 Right Tray Installation Yes/No.
Sim 26-35 Set Multi Error Counter Set to 1 (Multi Count).
Sim 26-78 Remote Desktop Access Password set.
CASSETTE SETUP & PAPER TYPE
Set cassette size by adjusting the guides in the cassette.
Paper Size & Type Setting:- System Settings – Paper Tray Settings
IMAGE WRITING DISTORTION – CMYK
SIM 50-22 Image Writing Adjustment
PRINT IMAGE MAGNIFICATION & OFF CENTRE
Automatic Adjustment:
Sim 50-28 BK MAG ADJUST (Magnification)
SETUP/PRINT ADJ (Offset)
Normally no need to adjust as set in factory
To Next Page
Loading...
