37
Gamma adjustment
Selects the tone difference of the brightness and
darkness of the image according to the type of
programme watched from a maximum of e3 to a
minimum of f3.
Film mode
Automatically detects a film-based source (originally
encoded at 24 or 25 frames per second, depending on
the vertical frequency), analyses it and then recreates
each still film frame for high-definition picture quality.
Item Description
Advanced (High)
Provides smoother image motion while
ensuring high-quality playback.
Advanced (Low)
Adjust effect to reduce judder from film
contents.
Standard
Detects, analyses, converts film source.
Off
Normal viewing mode.
NOTE
• Film mode is not selectable depending on the input signal
type.
DNR (Digital Noise Reduction)
“DNR” produces a clearer image (“Auto”, “High”,
“Middle”, “Low”, “Off”).
NOTE
• This function may not be available depending on the input
signal type.
Range of OPC
The brightness level range of the OPC sensor’s
automatic adjustments can be set according to your
preferences. The adjustment range of the OPC sensor
can be set to a maximum of e16 and a minimum of
f16.
NOTE
• The maximum setting cannot be set to a smaller number than
the minimum setting.
• The minimum setting cannot be set to a bigger number than
the maximum setting.
• The maximum and minimum settings cannot be set to the
same number.
• Depending on the brightness of the surrounding light, the
OPC sensor might not operate if the adjustment range is
small.
Audio settings
Go to “HOME” > “TV Menu” > “Setup” > “Audio”.
Setup
Bass
Auto volume
Audio
Treble
[Off]
STANDARD
CH list
Menu
Balance
L30
R30
:Back:Enter
: Select
ENTER
Audio
Auto volume
Different sound sources sometimes do not have the
same volume level, such as a programme and its
commercial breaks. This function reduces this problem
by equalising levels.
Item Description
High
Strongly reduces the volume gaps
among different sound sources.
Middle
Low
Slightly reduces the volume gaps among
different sound sources.
Off
Does not adjust the volume gaps.
Audio
Audio adjustment
You can adjust the sound quality to your preference with
the following settings.
Item
c (Cursor) d (Cursor)
Treble
For weaker treble For stronger treble
Bass
For weaker bass For stronger bass
Balance
Decrease audio
from the right
speaker
Decrease audio
from the left speaker
NOTE
• For resetting all adjustment items to factory preset values,
press
a
/b to select “Reset”, press ENTER, press
a
/b to
select “Yes”, and then press ENTER.
Basic adjustment
LC-6070UD1H_EN_book.indb 37LC-6070UD1H_EN_book.indb 37 1/2/2014 8:57:13 AM1/2/2014 8:57:13 AM
To Next Page
Loading...
Need help?
General