8
Protection against overturning
There is a danger of the product overturning in the case of a disaster or sudden collision. Carry out the following tip-
resistant measurement for your safety.
Anchoring the TV to the wall or a pillar
1 Affix the TV to the wall or a pillar using
extra strong ties and cup hooks.
View from the top
2
1
3
Tie (commercially
available)
Tie (commercially
available)
Cup hook
(commercially available)
Fixing the TV to the table
1 Place the TV on the table.
2 Pull the attached restraining bracket out so that it
is at a 90 degrees angle.
3 Insert commercially available screw in the hole of
the restraining bracket and tighten the screw to
secure the TV to the table.
• Use commercially available screw to firmly secure the TV.
CAUTION
• As this product is heavy, use a table that is wide
enough to support the product and capable of
withstanding the product’s weight. The table should be
set where it will not be overturned.
• Be sure to use at least two people when moving the TV.
Stand
Screw
(commercially
available)
Preparation
LC-6070UD1H_EN_book.indb 8LC-6070UD1H_EN_book.indb 8 1/2/2014 8:57:00 AM1/2/2014 8:57:00 AM
To Next Page
Loading...
