Sharp MX-2010U - Page 44

MX-3610N Dehumidifying heater 3 – 17
2) Pull the harness tightly in the arrow direction, and check to
confirm that there is no disconnection of the snap band and
that the square hole in the frame is not covered with the har-
ness.
3) Connect the connector of the heater harness unit, and attach
the earth wire.
Attach the earth wire at an angle of 45 degrees.
(5) Cabinet and heater cover attachment
1) Attach the cabinet.
2) Attach the heater cover.
(6) Paper feed unit attachment
1) Attach the paper feed unit.
45
q
2
1
2
1
2
1
2