MX-M700N SIMULATION 7 – 71
66-60
Purpose
Setting
Function (Purpose)
Used to set the ACR data.
Section
FAX
Operation/Procedure
1) Enter the number corresponding to the set item with 10-key.
The item list menu can be switched by pressing [P] key.
2) Press [START] key.
3) Enter the setting value with 10-key.
4) Press [START] key.
This simulation can be executed when soft SW 24-4 and 24-5 are
set to 1.
Display/Not display is switched by soft SW 24-4 and 24-5.
The digit limitation and characters allowed to be inputted depend
on the input item.
67
67-16
Purpose
Operation test/Check
Function (Purpose)
Used to check the operation of the network
card.
Section
MFP controller
Operation/Procedure
During check, "CHECKING" is displayed. When check is com-
pleted normally, "OK" is displayed. In case of an error, "NG" is dis-
played.
(Display message)
CHECKING Checking
OK Check end (Normal)
NG Check end (Error)
SIMULATION 66-60
ACR SETTING. SELECT NUMBER, AND PRESS START.
SWITCHING OF MENU:[#]
1.Local Carrier Number 2.Long-distance Carrier Number
3.Overseas Carrier Number 4.Bypass Number
5.User Area Code 6.Machine Code
7.Version 8.Through Number1
9.Through Number2 10.Through Number3
11.Through Number4 12.Through Number5
13.Through Number6 14.Through Number7
15.Through Number8 15.Through Number9
17.Through Number10 18.Through Number11
1
SIMULATION 67-16
NETWORK INTERFACE CARD CHECK.
NIC: CHECKING
To Next Page
Loading...
