39
Loading tab paper and transparency film
In addition to plain paper, tab paper, transparency film, and other special media can be loaded in tray 5 and tray 6.
To load tab paper or transparency film in tray 5 and tray 6 follow the steps below.
Loading tab paper
To use tab paper, the special guide must be attached as explained below.
Loading transparency film
1
Take out the tab paper guide.
The guide is stored under the cover of the large capacity trays.
When finished using tab paper, be sure to replace the guide.
2
Adjust the paper guide to the tab paper
position and load tab paper.
To adjust the paper guide, see Loading paper and changing the
paper size (page 37).
Load tab paper with the print side up and the tabs to the left.
Load so that the paper goes against the left side of the tray.
[Example]
Make sure that the positions of the tabs correspond with the originals as shown below.
3
Attach the special guide as shown.
Attach the guide over the paper.
4
Gently push the tray in and set the paper
type to tab paper.
Change the paper type setting to tab paper as explained in
"PAPER TRAY SETTINGS" (page 80) in the System Settings.
When loading transparency film, load the film face up in the vertical orientation with the rounded corner at
the top right.
ABC
DEF
GHI
JKL
1st sheet 2nd sheet 3rd sheet 4th sheet
Bottom
Top
1st sheet
Front
side
4th sheet3rd sheet2nd sheet
Originals Tab paper
Guide
To Next Page
Loading...
Need help?
General
