63
Loading paper
Follow the steps below to load paper in the inserter.
1
Adjust the guide to the size of the paper
you are loading.
Squeeze the guide lock lever to adjust the guide. When you
have finished moving the guide, release the lever.
When loading paper larger than 8-1/2" x 11"R or A4, be sure to
pull the tray extension all the way out. If the extension is not
pulled all the way out, the size of the loaded paper will not be
detected correctly.
2
Insert the paper along the guide as far as
it will go into the feeder.
Up to 200 sheets each can be loaded on the upper tray and the
lower tray.
The paper size is automatically detected. If the paper size is not
detected or you are using a special paper size, or if you need to
change the paper type, change the paper settings in "PAPER
TRAY SETTINGS" (page 80) in the system settings.
When loading paper, make sure that the guide is correctly adjusted to the width of the paper.
If there is a gap between the paper and the guide, or if the paper is bowed because the guide is adjusted to a narrower
width than the paper, a misfeed, skewed paper feeding, or creases in the paper may result.
To Next Page
Loading...
Need help?
General
