Sharp UX-B700 - Sending a Fax by Direct Keypad Dialing

Sending a Fax by Automatic Dialing
48
Sending a fax by Direct Keypad Dialing
You can also enter a full number with the number keys and then press the
key to begin dialing. You can use this method to dial a full number
when you don't need to speak to the other party before faxing.
START/
MEMORY
1 Load the document(s).
• If desired, press to set
the resolution and/or contrast.
2 Enter the number of the receiving machine by pressing the number
keys.
• If a pause is required between any of the digits to access a special service
or an outside line, press . The pause will appear as a hyphen (two
seconds per pause). Several pauses can be entered in a row.
3 Check the display. If the number of the receiving machine shown is
correct, press .
• If the number is not correct, press to backspace and clear one digit at
a time, and then re-enter the correct digit(s).
RESOLUTION/
RECEPTION MODE
FUNCTION
START/
MEMORY
STOP
READY TO SEND
all.bookPage48Wednesday,December11,200211:25AM