Sending a Fax From Memory
53
2. Sending
Faxes
4 Press to store the destination.
5 Repeat Steps 3 and 4 for each of the other destinations to which you
wish to send the fax (maximum of 20).
6 When you are ready to begin transmission, press .
• A Transaction Report is automatically printed out after Broadcasting is
completed. Check the "Note" column of the report to see if any of the
destinations are marked "Busy" or have a communication error code. If so,
send the document to those destinations again.
START/
MEMORY
Broadcasting using a Group Key
If the fax machines to which you want to broadcast have all been programmed
into one Group Key (see Storing numbers in Group Keys which follows), you
can perform the broadcasting operation using the following simplified
procedure:
1 Load the document(s).
• If desired, press to set
the resolution and/or contrast.
2 Press the appropriate Group Key.
Transmission will begin.
RESOLUTION/
RECEPTION MODE
READY TO SEND
17/G1
all.bookPage53Wednesday,December11,200211:25AM
To Next Page
Loading...
Need help?
General
