EasyManua.ls Logo

Sharp VL-C8000X

Sharp VL-C8000X
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
For safety, strictly observe the following
.Do
not open the case.
@Take
care to avoid flammables or other liquids and
metal objects from entering the unit. Should this
happen, switch the power off and have the Camcorder
checked by qualified personnel.
*Do
not disassemble or attempt to modify the unit.
l Do not operate the Camcorder during lightning
storms. Unplug power cables of any connected
equipment.
Avoid using the Camcorder under the following
conditions
*Places of extreme humidity or excessive dust.
l Near electrical appliances generating strong mag-
netic fields (fluorescent lights, televisions, speak-
ers).
@Steamy
or sooty places such as near a cooking
stove.
*Excessive mechanical shock or vibration.
*Extremely hot locations such as near heating.
@Wet
locations, such as near swimming pools,
bathtubs and the like.
DO not expose the Camcorder to extremely high
or low temperatures for long periods
l Never leave this Camcorder in direct sunlight, in a
closed car during summer or near a heater
-
this
will most likely deform the exterior and damage the
internal parts of the Camcorder.
l Do not store the Camcorder in places over
60°C.
l Do not use the Camcorder in places over
40°C.
l Do not use the Camcorder in places below 0%.
l Do not use the Camcorder in humid places over 80%
RH.
Store the Camcorder in a location that stays between
-
20°C
and
60°C.
Take extra care when recording outdoors
@Do
not drop or allow it to strike any hard or rough
surface. Protect from damage during transporta-
tion.
l Prevent the Camcorder from getting wet.
@At
the beach, keep away from salt water or spray and
prevent sand from entering the Camcorder.
@Avoid
aiming the lens at extremely bright objects
like the sun or other strong lights.
*Do
not direct the viewfinder eyepiece at the sun.
l Stop using the Camcorder during lightning storms.
BEFORE DISCONNECTING A POWER SOURCE,
ALWAYS SLIDE THE OPERATE SWITCH TO OFF
-
THE OPERATE INDICATOR WILL GO OUT.
Handling the Camcorder
l
Protect the microphone from damage.
l Keep the Camcorder horizontal during use, other-
wise the tape may become slack and be damaged.
*Do not carry the Camcorder by the viewfinder.
Loop the strap over your arm
-
should the Cam-
corder accidentally slip out of
will avoid damaging it.
_
/
/
your hand, you
*Cap the lens after use. Remember to switch the
power off.
@Do
not touch the focus ring while using Autofocus.
*Before attaching any filter to the lens, switch to manual
focus or switch the power off and remove the lens
hood.
Cleaning the Camcorder
*Detach the battery pack or disconnect the power
before cleaning the Camcorder.
@Remove dust with a soft cloth. Use a soft cloth
moistened with mild detergent to remove persistent
dirt.
l Do not use strong cleaning agents such as PETROL,
thinner or alcohol
-
they may damage the exterior.
*Keep the lens and viewfinder clean. Clean the lens by
first blowing it free of dust, then gently wipe it with a soft
brush or lens cleaning paper moistened with lens
cleaning fluid.

Related product manuals