INSTALLING THE LITHIUM BATTERY
1
Open the lithium battery compartment cover with
2
Insert the battery with the
“
+
”
side out. Close the
a pointed object.
lithium battery compartment cover.
l
For battery
replace-
ment, repeat step 2
after removing old
battery.
Warning:
l Dispose
of used battery
promptly. Keep
away from children.
Do not disassemble and do not dispose of in fire.
l
The battery used in this device may present a fire or chemical
burn hazard if mistreated. Do not recharge, disassemble,
heat above
100°C
or incinerate. Replace battery with type
CR2025 of SHARP CORPORATION, SONY ENERGYTEC,
FUJI ELECTROCHEMICAL or MATSUSHITA ELECTRIC
only. Use of another battery may present a risk of fire or
explosion.
SETTING THE DATE/TIME
l
This lithium battery is available at a local electronic appliance
shop or audio/video shop.
l
Disconnect the power source
(AC
adaptor, battery pack, etc.)
before replacing the battery.
l The battery life is approximately one year but it differs de-
pending on the ambient temperature and the condition of the
lithium battery.
l When the lithium battery runs out, the clock may be ex-
tremely inaccurate, or the clock setting mode may be
engaged. When this occurs, replace the lithium battery
as soon as possible.
Reset the date and time after replacing the battery.
l
Do not short-circuit the battery by holding the electrodes with
metallic objects such as tweezers, as doing so will deteriorate
the battery quality.
The auto date/time function features a date and time in the viewfinder which can be recorded as a handy reference.
Follow
the instructions below to set the current date and time.
Example: Setting the date to 25th Oct. 1991 and time to
3:27
PM.
1
Install the date/time lithium battery.
2
Connect a battery pack or power source. Slide
the OPERATE switch on.
Press the DATE-TIME DISPLAY button (See
page 6 No.33)
3
Press the INITIAL button using a dull-pointed
4
The day will flash. Press the SELECT button to
object such as a ball point pen.
select the day. When the correct
d,ay
appears,
press the SET button.
c-
DATVnME
SET
-
SELECT
-
INmAL
I
Q
TRACKING >
5
The month will flash. Press the SELECT button
to select the month. When the correct month
6
The year will flash. Press the SELECT button to
select the year. When the correct “tens” of the
appears, press the SET button.
year appears, press the SET button.
7
The hour will flash. Press the SELECT button to
8
The minutes will flash. Press the SELECT
but-
select the hour (check for AM or PM). When
ton to select the minutes. When the correct time
the correct hour appears, press the SET button.
appears, press the SET button.
7
To Next Page
Loading...
Need help?
General
