mode is engaged.
ppears when the
BLC/
pressed while
ck
mode is
en-
appears when the
CE button is pressed.
ade stand-by mode
is engaged.
en the REC
START/STOP
button is
pressed,
Fade in or Fade out is ob
m
If you use a TV as a monitor, only the date or date/time appear in the viewfinder.
AUTO DATE/TIME FUNCTION
The auto date/time function features a date and time
which can be recorded as a handy reference.
Follow the procedures outlined below for recording the
date or date/time along with the subject.
If the date and time are not set, the DATE-TIME DISPLAY but-
ton will not function. (See page 7.)
1
2
3
Connect to a power source and slide the OPERATE switch to on. Slide the CAMERA
RECNCR
PLAY switch to
“CAMERA REC” and the Camcorder will change to REC PAUSE.
Press the DATE-TIME DISPLAY button. Either the date or date/time will be displayed in the viewfinder. Pressing
this button changes the display in the viewfinder as follows, and either the date or date/time can be set.
,
PM327
+
b
10.27.91
10. 27. 91
I
Press the REC START/STOP button. The date or date/time displayed in the viewfinder will be
recorJed
along with
the subject.
21
To Next Page
Loading...
