To avoid serious injury or death,
the safety arm must be installed
after the Post Driver has been
mounted on a machine, or the
freestanding Post Driver has been secured
to prevent tipping.
7. Pull swing arm handle around toward the
Post Driver I-beam until the swing arm
clears (swings past) safety arm frame (I2)
bracket stop.
8. Tap swing arm shaft up through safety arm
frame tube.
9. Install Lynch pin (I13) to secure the swing
arm to the safety arm frame.
10. Verify the swing arm handle opens against
safety arm frame (I2) stop bracket and
closes against back wall of drive ram (A1)
I-beam.
(
A1) Drive Ram. (I2) Safety Arm Frame.
NOTE: When driving a fence post, the swing
arm rollers must contact and hold the fence
post in position, as shown.
To Next Page
Loading...
