15. Do not operate the Post Driver with the
machine or power source unattended.
The Post Driver requires two people for
proper operation - one operating the Post
Driver and one on the tractor.
16. Always engage the road lock pin in the
drive ram lower hole before transporting
and in the upper hole for storage.
Operating Instructions
Mounting
1. With the Post Driver positioned on a hard
level surface, move the tractor or other
power supply toward the Post Driver until
the three-point hitch lines up.
2. Attach two lower, three-point hitch lift arms
to Post Driver three-point hitch weldment
(K1) hitch pins. Secure with lock pins
(operator supplied).
3. Attach the three-point top link to removable
pin (B8) Secure upper pin with Lynch
pin (B9).
NOTE: Adjust the length of the machine’s top
link, as required, to correctly attach the Post
Driver.
(K1) Three-Point Hitch Weldment. (B8) Top Link Pin.
(B9) Lynch Pin.
NOTE: The HD-10 and HD-10-H Post Driver
will fit tractors with Category II or Category III
three-point hitches. Use bushings
(operator supplied) on the hitch pins, if
required, to correctly install the lift arms.
4. Attach hydraulic pressure supply hose
(small diameter, G17) to the tractor
pressure supply port. Attach hydraulic
return hose (larger diameter, G20) to the
tractor return port.
(G1 or H1) Control Valve. (G17) Hydraulic Pressure
Supply Hose. (G20) Hydraulic Return Hose.
NOTE: The operator is responsible for
installing quick-disconnect fittings (or other
suitable fittings) on the Post Driver hoses.
Make sure the fittings are compatible with the
tractor hydraulic fittings.
22
To Next Page
Loading...
