Shimadzu AA-6800F - Refer to Parameters]

5.4 [Refer to Parameters]
5-15
AA-6800/6650 Instruction
Clicking on [Parameters] in the menu bar during the measurement opens a drop-down menu.
Figure 5.12 [Parameters] Drop-Down Menu
Selecting [Refer to Parameters] from this drop-down menu opens the property sheet, which is a dialog box to
show the parameters for the element under measurement. The parameters can be shown but cannot be
changed. To change the parameters, stop the measurement once and select [Parameters]-[Edit Parameters]
from menu bar (refer to section 5.6).
NOTE
If a dialog box ([Coating and Boost Cycles], etc.) is opened in the sheet for referring to the parameters, the
measurement operation is stopped temporarily. Therefore, close the dialog box immediately after referring to
the necessary parameters.
5.4 [Refer to Parameters]