Chapter 4 Basic Operation
4-4
AA-6800/6650 Instruction
With the AA software, after starting up the software, you can set the necessary settings for the measurement
just by following the instructions sequentially displayed on the screen (Wizard function). In this section, the easy
operation using this Wizard function is described for each of flame and furnace methods in regular sequence.
Refer to
Chapter 5 for details of each items.
4.2.1 Software Basic Operation (Flame Method)
4.2.1.1 Operation Flowchart (Flame Method)
This Wizard has a sequence for setting as shown below. You can proceed to the next step or return to the
preceding step by using the [Next] or [Back] button, respectively.
(Starting up the AA Software)
p
(1) Wizard Selection
p
(2) Element Selection
p
(3) Preparation Parameters
p
(4) Sample ID
p
(5) Sample Selection
p
(6) Connect to Instrument/Send Parameters
p
(7) Optics Parameters
p
(8) Atomizer/Gas Flow Rate Setup
p
(Finish)
p
(Start Measurement)
NOTE
When measuring plural elements, you cannot set parameters for the elements other than the current
measurement one on the [Optics Parameters] and [Atomizer/Gas Flow Rate Setup] pages. If you use the
ASC to measure plural elements automatically and you need to modify the parameters for other elements
than the current measurement one, you can change these parameters by using the [Edit Parameters] button
in the [Element Selection] page.
4.2 Software Basic Operation
To Next Page