Shimadzu AA-6800F - Software Basic Operation (Furnace Method); Operation Flowchart (Furnace Method)

4-19
4.2 Software Basic Operation
AA-6800/6650 Instruction
4.2.2 Software Basic Operation (Furnace Method)
4.2.2.1 Operation Flowchart (Furnace Method)
This Wizard has a sequence for setting as shown below. You can proceed to the next step or return to the
preceding step by using the [Next] or [Back] button.
(Starting up the AA Software)
p
(1) Wizard Selection
p
(2) Element Selection
p
(3) Preparation Parameters
p
(4) Sample ID
p
(5) Sample Selection
p
(6) Connect to Instrument/Send Parameters
p
(7) Optics Parameters
p
(8) Furnace Program
p
(Finish)
p
(Start Measurement)
NOTE
When measuring plural elements, you cannot set parameters for the elements other than those for the
current measurement on the [Optics Parameters] and [Furnace Program] pages. If you use the ASC to
measure plural elements automatically and you need to change the parameters for the elements other than
those for the current measurement, you can change these parameters by using the [Edit Parameters] button
in the [Element Selection] page.